MSDS - Rotovac Odor Kill

MATERIAL SAFETY DATA SHEET

 

Complies with OSHA hazard communication standard 29 CFR 1910.1200

HMIS Rating
Scot Laboratories Phone: (440) 543-3033 Health- 1
16841 Park Circle Drive Fax: (440) 543-1825 Fire- 0
Chagrin Falls, OH 44023 Date: December 9, 2002 Reactivity- 0
0=minimal, 1=slight, 2=moderate, 3=serious, 4=severe

 

SECTION I - Product Identification
Product Name: "ODOR" Odor Kill Product Code: 297

SECTION II - Hazardous Ingredients/Identity Information
Hazardous Components CAS No. OSHA PEL ACGIH TLV OTHER LT
None

SECTION III - Physical/Chemical Characteristics
Physical State: Liquid Vapor Density
(AIR = 1):
Heavier than air
Color and appearance: Clear, Yellow pH: 7.3 +/- 0.7
Odor: Fresh lavender Solubility in Water: Complete
Boiling Point: 212ºF Specific Gravity (H2O=1): 1.00
Melting Point: 32ºF Evaporation Rate: <1 (Butyl Acetate=1)

SECTION IV - Fire and Explosion Hazard Data
Flash Point: None
Flammability Limits in Air: None
Extinguishing Media: Water, foam, or carbon dioxide
Special Fire Fighting Procedures: None
Unusual Fire or Explosion Hazards: None

SECTION V - Reactivity Data
Stability: Stable
Material to Avoid: Do not mix with other chemicals. Follow instructions on label.
Conditions to Avoid: Unknown
Hazardous Decomposition or Byproducts: Unknown (Hazardous Polymerization will not occur)

SECTION VI - Health Hazard Data
Product hazard classification: None
Carcinogenic ingredients: Unknown
Effects of overexposure: Ingestion may cause nausea or diarrhea. May be irritating to eyes.
Medical Conditions aggravated by use: Unknown
+ First Aid Procedures +
INGESTION: Do not induce vomiting, drink plenty of water, contact a physician immediately.
SKIN/EYE CONTACT: Flush with water for 15 minutes. If irritation persists, consult a physician.

SECTION VII - Precautions for Safe Handling and Use
In case of Release or Spill: Recover liquid with absorbent. Mop up or wet vac. Rinse area with water to remove.
Waste Disposal Method: Small amounts - down drain or sanitary landfill.
Large amounts - obey local ordinances.
Handling and Storing: Do not store near heat. Do not freeze.
Other Precautions: If frozen, thaw to room temperature and mix before using. Do not pour unused portion back into container - it may contaminate product.

SECTION VIII - Control Measures
Gloves: None Respirator: None
Eye Protection: None Ventilation: Local exhaust is normally adequate.
Other Protection: None Work/Hygienic Practices: Follow good manufacturing and housekeeping rules.

SECTION IX - Special Precautions
- Avoid temperature extremes. Do not store below 40ºF or above 130ºF.

SECTION X - Department of Transportation
Shipping Hazard Classification: None

DISCLAIMER

The information contained herein was obtained from current and reliable sources. However, the data is provided without any warranty, expressed or implied, regarding its correctness or accuracy. Since the conditions for use, handling, storage and disposal of this product are beyond Scot Laboratories' control, it is the user's responsibility both to determine safe conditions for use of this product and to assume liability for loss, injury, damage or expense arising from the product's improper use. No warranty, expressed or implied, regarding the product described herein shall be created by or inferred from any statement or omission in this MSDS. Various government agencies (e.g., DOT, EPA, FDA) may have specific regulations concerning the transportation, handling, storage, use or disposal of this product which may not be reflected in this MSDS. The user should review these regulations to ensure full compliance.